Pure Plus

Daily hard surfaces: Add about a cup (200ml) of fresh water to empty 1L applicator bottle, then for convenience add 1 plunge (30ml) of Pure Plus - which is slightly more than recommended. Add more fresh water to the 1L mark, then spray as required. Critical hard surfaces: Add about a cup (200ml) of fresh water to empty 1L applicator bottle, then for convenience add 4 plunges (120ml) of Pure Plus - which is slightly more than recommended. Add more fresh water to the 1L mark, then spray as required. Laundry: 1:20 (5% soln, 50ml per litre). Kitchen & Bathrooms: Wet mop or wipe at 1:50 (2% soln, 20ml per litre). Outdoor Hard Surfaces: 1:5 to 1:1 (20% - 50% soln.) Health Department Guidelines for Hospital & Daycare Surfaces: 1000PPM (2% soln) for daily/frequent use. Never use on wool or silk, and not recommended for use on coloured or sensitive garments as streaking, fading or other deterioration could result.

Under Good Practice Protocol based on accepted international research a 1% solution of this product diluted with potable water is recommended with liberal application on clean hard surfaces with a minimum contact time of 5 minutes. At this concentration the product provides 500PPM FAC. NZ Ministry of Health requirements for use in Early Education facilities is for use of this product as follows: 2% solution = 1000PPM for daily surfaces.* 10% solution = 5000PPM for critical surfaces.* * ”Surfaces” as listed appropriate by NZ Ministry of Health (MOH); taps, toilet seats, door handles, change tables and janitorial floors.